QMP6988 Temperature+Pressure Sensor
The qmp6988 sensor platform allows you to use your QMP6988
(datasheet,
M5Stack_) temperature and pressure sensors with ESPHome. The I²C is
required to be set up in your configuration for this sensor to work.
# Example configuration entry
sensor:
- platform: qmp6988
temperature:
name: "Living Room Temperature"
oversampling: 16x
pressure:
name: "Living Room Pressure"
oversampling: 16x
address: 0x70
update_interval: 60s
iir_filter: 2xConfiguration variables
temperature (Optional): The information for the temperature sensor
oversampling (Optional): The oversampling parameter for the temperature sensor. See Oversampling Options.
All other options from Sensor.
pressure (Optional): The information for the pressure sensor.
oversampling (Optional): The oversampling parameter for the temperature sensor. See Oversampling Options.
All other options from Sensor.
address (Optional, int): Manually specify the I²C address of the sensor. Defaults to
0x70.0x56is also configurable - see datasheet.iir_filter (Optional): Set up an Infinite Impulse Response filter to increase accuracy. One of
OFF,2x,4x,8x,16x,32x. Defaults toOFF.update_interval (Optional, Time): The interval to check the sensor. Defaults to
60s.
Oversampling Options
By default, the QMP6988 sensor has been configured to measure each value 8 times when requesting a new value. You can, however, configure this amount. Possible oversampling values:
NONE(value is skipped)1x2x4x8x(default)16x32x64x
